• What’s new in turning? A lot!

    Louis Martineau
    Technical Consultant — Advanced Manufacturing at SolidCAD

    I mentioned in my last entry that Turning saw some important (and overdue) improvements of late. Indeed, you may have noticed that the Turning/Profiling function has been broken into a dedicated roughing strategy and a dedicated finishing strategy, for much more control and to allow for output of canned cycles. This happened around the middle of last year for Fusion, and a bit later for Inventor CAM.

    What you may not have noticed, however, is a myriad of small but very-welcome improvements everywhere else too. It’s a long list, and I refer you to Marti Deans’ excellent coverage here: https://www.autodesk.com/products/fusion-360/blog/turning-updates-fusion-360/

    Also, as I said in my last post, this is apparently just the tip of the iceberg. Turning experts have joined the Fusion development team and are hard at work implementing more functionality and innovative technologies (like Adaptive Turning). I hope to see a lot of the power of PartMaker ported to Fusion CAM!